Art Schubert has been turning ideas into reality at RJG since 1989. Now Chief Engineer at RJG, Art is committed to sharing his extensive knowledge with others and helping molders avoid common pitfalls. He continues to research future applications on behalf of the company. His encyclopedic knowledge of all things injection molding makes Art a tremendous resource for technical information. You can subscribe to Art's Tips and search our knowledge base for information on your topic of interest.

Tip of the Day 163: Alarms for Missing Sensors

In tip #162 we showed how alarms can be reduced from 32 to just 2. However this will not detect a sensor being disconnected. To do that you need to add some "dummy" alarms that will go to "Warning" when a sensor is missing. The eDART's™ phantom curve generator creates #H... Read Full Tip

Most Viewed Articles

Tip of the Day 53: Set Fill Volume to get Good Viscosity

Tip of the Day 45: Always Monitor Viscosity

Tip of the Day 15: What are Fill and Pack?

Tip of the Day 6: How much is enough?

Tip of the Day 14: Not So Independent Variables

3111 Park Drive
Traverse City, MI 49686
P. 231 947-3111
F. 231 947-6403